How do i get it lighted up :)

[Fille]

i want the black lines to be seen in 4 red leds.
I can take the dremel and make a "hole"-
or i can take som frost spray and spray that on?
what do you think i should do?
:dremel: or Spray?

[fivecheebs]

What black lines?

Basically, if you want the edges to light up, then well positioned LEDs alone should do it. If you want to liket up a whole panel then you need something for the light to reflect off. etch, sand or spray frosting would all work giving different effects.

[Fille]

omg i forgot to post the picture :P hehe sorry!

[Reitau]

Could use EL string? run it along the text - its very bendy stuff, would look ccol 'glowing' too.

[fivecheebs]

hehe!. I would dremel/laser etch that if it were me.

[fillip]

hehe!. I would dremel/laser etch that if it were me.

Definately. Stick leds at the edges; 1 at each end and 2 - 3 on the bottom and top edges, and etch the design onto the perspex. :thumb:

[Fille]

:) yeah i think i go for the dremel!:dremel:

Maybe i can use a Mobilephone charger to give it power? 4 leds?
is that posible. the nokia is running 5 V out i think.<_<

i etch the lines and put the other plexi over.

[fivecheebs]

Any DC PSU will do, Just adjust the value of the current limiting resistor accordingly.