toby
29th December 2004, 21:11
Here is some work i have been doing on sketchup on a case. The case is a juno P6 tower and has had some of its bottom half taken off and the bottom of the case shunted up, this is to create a nice compartment like a lian li case, one side will hold the psu and the other side will house the pump and a small res.
The front still needs a hole for a fassmatic and some sort of airflow into the front of the case and a slot for a dvd drive at the top, i need to get the measurements for these. Then the rad needs the exact width of the compression fittings i can use before i can get it made. The side needs the measurements for the small innovatek radiator and an air intake for the power supply.
any advice on my placement of stuff on the front panel would be nice. The actual main case isnt 100% on the insides and at the back. I will take pics of the main case when i get time. wondering who i can get to make this for me tho cause the rad would be quite strange to do.
Side Panel(exciting)
http://www.h2omods.com/miscstuff/panel1.jpg
Main Block
http://www.h2omods.com/miscstuff/mainblock.jpg
Front Panel
http://www.h2omods.com/miscstuff/front.jpg
Radiator that will sit on top of the case
http://www.h2omods.com/miscstuff/Toprad.jpg
http://www.h2omods.com/miscstuff/Toprad2.jpg
So any thoughts or comments on it, i would like to hear them, i hope to have it all made out of alu and chromed. oh and i already know that the rad isnt going to be awesome for cooling and will probs require a high flow. Basicly the idea of the rad is that the water is split and goes into the two inner holes at the back then there are tubes connecting each row of holes together and then the water goes out of the far back tubes to the specific on each side of the case, kinda hard to explain but i hope someone out there gets it
The front still needs a hole for a fassmatic and some sort of airflow into the front of the case and a slot for a dvd drive at the top, i need to get the measurements for these. Then the rad needs the exact width of the compression fittings i can use before i can get it made. The side needs the measurements for the small innovatek radiator and an air intake for the power supply.
any advice on my placement of stuff on the front panel would be nice. The actual main case isnt 100% on the insides and at the back. I will take pics of the main case when i get time. wondering who i can get to make this for me tho cause the rad would be quite strange to do.
Side Panel(exciting)
http://www.h2omods.com/miscstuff/panel1.jpg
Main Block
http://www.h2omods.com/miscstuff/mainblock.jpg
Front Panel
http://www.h2omods.com/miscstuff/front.jpg
Radiator that will sit on top of the case
http://www.h2omods.com/miscstuff/Toprad.jpg
http://www.h2omods.com/miscstuff/Toprad2.jpg
So any thoughts or comments on it, i would like to hear them, i hope to have it all made out of alu and chromed. oh and i already know that the rad isnt going to be awesome for cooling and will probs require a high flow. Basicly the idea of the rad is that the water is split and goes into the two inner holes at the back then there are tubes connecting each row of holes together and then the water goes out of the far back tubes to the specific on each side of the case, kinda hard to explain but i hope someone out there gets it