PDA

View Full Version : AquaComputer Flow Sensor Setup

cools
22nd December 2004, 01:11
Finally got my Aquaero connected up via USB, and reflashed to latest + English, and I'm able to fiddle about easily.

I have a question though. The flow sensor that is connected, is there standard pulse per litre setting for it? I can make it say anything from 0.1 litre per min up to 13 litre per min, and I don't have a clue which is correct!
fillip
22nd December 2004, 01:16
13 LPM for a low flow setup doesn't sound right, but just as 0.1 LPM is clearly wrong also.

I wont insult you by asking if you looked in any supplied manual but I found this PDF - http://www.aqua-computer.de/download/AC_aquaero20040726engl.pdf

Page 21 mentions a value to enter for correct calibration, dunno if that helps at all...
cools
22nd December 2004, 02:02
No manual came with the sensor, and of course the Aquaero manual was in german :)

Cheers for the link, although the manual suggests 550 pulse per litre, that gives me a result of 0.2 litres a minute :D

More digging needed methinks.
fillip
22nd December 2004, 02:09
It also says 550 is the default and it should be adjusted depending on the sensor used. Don't s'pose there are any details with it since you don't get a manual of any kind.

I'll keep searching for you too.
kazuo
22nd December 2004, 10:29
509 pulse per litre
londonmark69
8th February 2005, 05:22
What was it exactly that you flashed your AQUAERO with to make it display english? I don't suppose by some chance you still have the file? If so could you either post a link to its origin, or I will PM you with my email address, for you to sent it to me as an attachment - whichever is easiest for you. Many thanks in advance. Mark
Pug
8th February 2005, 07:16
What was it exactly that you flashed your AQUAERO with to make it display english? I don't suppose by some chance you still have the file? If so could you either post a link to its origin, or I will PM you with my email address, for you to sent it to me as an attachment - whichever is easiest for you. Many thanks in advance. Mark
You might find this post useful - http://www.wizdforums.co.uk/showpost.php?p=7257&postcount=11 :)
londonmark69
8th February 2005, 13:10
As always MANY thanks ,mate, after having to use sarcasm on the aqua computers site english forum, i was finally given an answer, that being i have to wait flor the new firmware release to get my particular version to display in english, as its newer than the download from thier site.
Not to worry, thanks again.